These are the accessories available for the P3D chambers.
If you have question or would like to receive additional information about the P3D accessories and consumables, do not hesitate to contact us!
The table below shows the main technical specifications of the EBERS TEB500 bioreactor.
|Temperature range||Room temperature +5 to +50 ºC|
|Control||± 0.1 ºC|
|Stability||± 0.1 ºC|
|Uniformity||≤± 0.35 ºC|
|Stability||± 0.1 ºC|
|Service pressure||0.7 bar|
|Service pressure||1 bar|
|Number of pumps||Two independent subsystems with electric motors and electronics located outside the internal chamber to avoid overheating, reduce the risk of contamination and increase useful volume|
|Number of pumpheads||1 multichannel pumphead per subsystem|
|Channels per pumphead||4|
|Flow rate||0.0002-49 ml/min per channel|
|Front display control|
|Controlled variables||Temperature, CO2 and O2|
|PC-based interface control|
|Controlled variables||Temperature, CO2, O2 and flow conditions|
|Interface compatibility||Windows and Linux environments|
|Windows systems requirements||
|Linux systems requirements||
|Power supply and consumption|
|Power supply||110-220 V, 50-60 Hz, IEC 14 power cord|
|Nominal power||650 W|
|Dimensions and Geometry|
|External dimensions [W x D x H]||750 x 741 x 360 mm|
|Internal dimensions [W x D x H]||650 x 530 x 200 mm [W x D x H]|
|Internal volume||60 l|
|Opening system||Double top door construction|
Please contact us for further information if you want to know more about the TEB1000.
The TEB500 series has been specifically conceived to carry out cell culture experiments under flow conditions. Moreover than providing the temperature and gas conditions necessary for cell growth, it incorporates two fully integrated peristaltic pumping systems equipped with multichannel pumpheads. The TEB500 has been designed with a double top door system in order to improve the accessibility to the flow circuits. In addition, it counts on the most advanced autocalibration, remote operation and data logging systems which make it a reliable and robust cell culture equipment.
The TEB500 series is equipped with CO2 and O2 controls in its standard version and allows the user to:
The fully integrated configuration of the TEB500 is able to substitute a large number of equipments frequently used for cell culture in Tissue Engineering, like a CO2 incubators, peristaltic pumps and heaters, since it integrates all their capabilities, allowing a wide variety of experimental set-ups including: